24- and 48-Port Cisco 3560 Switches

Attaching Brackets to the Catalyst WS-C3560V2-48PS-S Switch

The bracket orientation and the brackets that you use depend on whether you are attaching the brackets

for a 19-inch or a 24-inch rack.

 • For 19-inch racks, use bracket part number 700-8209-01

 • For 24-inch racks, use bracket part number 700-13248-01.

After the switch is mounted in the rack:

1. Connect to a 10/100 or 10/100/1000 port, and run Express Setup. STo use the CLI setup program,“Configuring the Switch with the CLI-Based Setup Program.”

2. Connect to the front-panel ports.

 • Catalyst 3560-24PS, 3560-24TS-S, 3560-48PS, and 3560-48TS-S

 • Catalyst 3560G-24PS, 3560G-24TS, 3560G-48PS, and 3560G-48TS

These switches wall-mount with the front panel facing up or down:

 • Catalyst 3560V2-24PS, 3560V2-24TS, 3560V2-48PS, and 3560V2-48TS

After the switch is mounted in the rack:

1. Power on the switch. 

2. Connect to a 10/100 or 10/100/1000 port, and run Express Setup.  To use the CLI setup program,

3. Connect to the front-panel ports.

Table- or Shelf- Mounting

Step 1 Locate the adhesive strip with the rubber feet in the mounting-kit envelope. Attach the four rubber feet

to the bottom of the switch near the corners.

Note Do not attach the rubber feet over the recessed screw holes on the bottom of the switch.

Step 2 Place the switch on the table or shelf near an AC power source.

After the switch is mounted in the rack:

1. Power on the switch. See the “Verifying Switch Operation” section on page 2-6.

2. Connect to a 10/100 or 10/100/1000 port, and run Express Setup.

Getting Started Guide for instructions.

3. Connect to the front-panel ports.

For more Cisco information please click here

http://www.3anetwork.com/cisco-ws-c3560x-48pf-l-price_p60.html